• Uniform plasticity
• High viscosity
• Quick hardening
• Low fusing material

• 1 x Samit Tracing Stick

Prepare the Tray:

• Choose an appropriate impression tray for the patient.
• Ensure the tray is clean and dry before application.

Heat the Tracing Stick:

• Gently heat the Samit Tracing Stick using a flame or in hot water until it becomes soft and moldable.
• Avoid overheating as it can affect the material's properties.

Apply the Material:

• For border extensions, apply the softened material to the edge of the impression tray.
• For muscle trimming or sulcus depth recording, mold the material around the areas where anatomical adjustments are needed.
• If modifying a dentate tray, build up the material over areas where a tooth has been extracted.

Insert Tray into Patient's Mouth:

• Insert the tray carefully and have the patient perform functional movements to ensure proper muscle trimming.
• This helps to shape the material to the contours of the oral cavity.

Harden the Material:

• Once the desired shape is achieved, remove the tray and quickly dip it into cold water.
• This will harden the material and set the impression.

Check and Adjust:

• Inspect the borders and fit. If necessary, reheat the material for further adjustments.
• Finalize the impression for further use in relining or functional impression techniques.