Composition:

• Fluoroaluminosilicate glass powder, Modificator
• Polyacrylic acid, Maelic acid, Tartaric acid (Liquid)

Properties:

• High biocompatibility
• 185MPa strength
• Acid erosion resistance
• Fluorine-containing glass filler for anticaries effect

Indications:

• Crowns
• Dental bridgework
• Inlays
• Onlays
• Orthodontic Brackets

Method of Use:

• Surface preparation
• Mixing
• Application

Storage:

• Temperature: 5°C to 25°C
• Dry place, away from humidity
• Shelf life: 3 years

• 1 x Powder (35g bottle)
• 1 x Liquid (25g bottle)
• 1 x Measuring spoon
• 1 x Mixing pad

Surface Preparation:

• Ensure the tooth stump is prepared, cleaned, and dried.
• Treat the tooth stump with conditioner using an applicator (cotton ball or sponge) for 10-15 seconds.
• Thoroughly clean the cavity with water for 10-15 seconds and dry it slightly until a glossy surface is achieved. Do not over-dry.

Mixing:

• Shake the jar of powder before use without turning it over, tapping on your palm.
• Mix the powder with the liquid on a mixing pad or glass plate using a plastic or metal spatula at room temperature (18-23°C).
• Follow the recommended ratio of powder to liquid (1.4g powder to 1.0g liquid).
• Mix for 30-45 seconds until a plastic consistency is obtained.

Application:

• Insert the material into the crown and fix it on the prepared tooth stump without over-compressing.
• Patient should articulate and apply constant pressure until the material hardens (2.0-2.5 minutes).
• Remove excess material and ensure a snug fit.

Post-Application:

• Advise the patient not to eat for 2 hours after application.
• Clean metal instruments immediately after use.
• Tightly close the container after each use.
• In case of contact with eyes, skin, or oral tissues, remove the material immediately and wash with water.