• Bonding System: 5th Generation Total-Etch
• Adhesion Strength: 27 MPa
• Storage: 5 °C to 25 °C, dry place, protected from light, tightly closed container
• Recommended Application Time: 15 seconds on prepared tooth surface
• Application: Light-curing single-component adhesive material

• 1 x Dropper bottle (5 ml)

Preparation:

• Ensure proper isolation using a rubber dam or cotton rolls and a saliva ejector to protect the working surface from saliva.
• Employ standard methods of cavity preparation for hard tooth tissues.

Deep Cavity Preparation (if applicable):

• For deep cavities, perform pulp capping using calcium hydroxide material.
• Isolate with glass ionomer cement only close to pulp dentine, leaving the rest of the dentine surface open for adhesive treatment.

Application of SafeEndo ReCreate Bond 5:

• Shake the dropper bottle well before use.
• Apply the adhesive after the etching procedure with 1-2 coats on the prepared tooth surface for 15 seconds.
• Slightly dry the adhesive with air for 5 seconds (to prevent splashing), then further dry for another 5 seconds with a strong air flow.
• Ensure even coverage and provide photopolymerization with a light source emitting wavelengths of 400-500 nm for 20 seconds.
• Keep the waveguide endface in close proximity to the curable material during curing.
• For larger cavities, divide them into smaller sections and cure each sector separately.

Post-Application:

• Do not remove the formed inhibited layer, as it promotes binding with the composite material.

Storage and Handling:

• Store SafeEndo ReCreate Bond 5 in a dry place protected from light at a temperature between 5 °C to 25 °C.
• Tightly close the container immediately after use to prevent solvent evaporation.

Safety Precautions:

• Avoid using eugenol-containing materials, as eugenol disrupts the adhesive's structuring.
• In case of accidental contact with oral mucosa, eyes, or skin, rinse the affected area with a large amount of water.