• Powder: Fluoroaluminosilicate Glass Powder, Modificator, Dye stuff<br>
• Liquid: Polyacrylic acid, Maleic Acid, Tartaric acid
• Strength: 190MPa
• Acid Erosion Resistance: < 0.002mm/h
• Biocompatibility: High
• Adhesion: Chemical (Polyacrylic acid with dentin calcium)
• Fluoride Release: Yes
• Working Temperature: 32°C to 42°C (oral cavity temperature: 37±1°C)
• Working Time: 2.0-2.5 minutes
• Hardening Time: 4-5 minutes
• Storage: 5°C to 25°C
• Shelf Life: 3 years

• 1 x 20g Powder (bottle)
• 1 x 15g(13 ml) Liquid (bottle)
• 1 x Measuring spoon
• 1 x Mixing pad

Surface Preparation:

• Ensure the tooth stump is prepared, cleaned, and dried.
• Treat the surface with a conditioner using an applicator (like a cotton ball or sponge).
• Thoroughly clean the cavity with water after 10-15 seconds, ensuring a glossy surface.
• Avoid over-drying the cavity.

Mixing:

• Shake the powder jar before use.
• Mix the powder and liquid according to the recommended ratio (1 dose meter of powder spoonful to 1 drop of liquid).
• Mix on a mixing pad or glass plate using a plastic or metal spatula at room temperature (18-23°C).
• Follow the specified mixing time (30-45 seconds).

Working and Hardening:

• Once mixed, the working time is 2.0-2.5 minutes.
• Apply the cement to the cavity and shape it within the working time.
• Remove excess material carefully to avoid air bubbles.
• The hardening time from the start of mixing is 4-5 minutes.

Final Filling Treatment:

• After hardening, apply a thin layer of varnish using an applicator and dry slightly with air.
• Polish the filling with polishing pastes after 10 minutes.
• Advise the patient not to eat for 2 hours after application.

Safety Precautions:

• Tightly close the container after each use.
• In case of contact with eyes, skin, or oral tissues, remove the material immediately and wash with water.

Note: Follow storage instructions (5°C to 25°C) and do not use the product after the expiry date.