• Magnesium oxide
• Strontium Chloride
• Tannic acid
• Liquid: Poly acrylic acid

Preparation: Ensure all tools and surfaces are clean and dry before use. Dispense the powder and liquid in the recommended ratio (usually provided on the product label or insert).

Mixing: Place the appropriate amount of powder onto the mixing pad.

• Using the spoon, create a small depression in the powder.
• Dispense the liquid into the depression.
• Using the mixing spatula, gradually incorporate the powder into the liquid. Mix thoroughly to achieve a smooth, homogenous consistency.

Application: For cementation: Apply the mixed cement to the fitting surface of the restoration (crown, bridge, inlay, or orthodontic bracket) and seat it immediately.

• For cavity lining: Apply a thin layer of cement to the prepared cavity floor.
• For temporary fillings and pulp-capping: Place the mixed cement into the cavity, ensuring it covers the exposed dentine.

Setting: Allow the cement to set undisturbed. The setting time will vary depending on the product specifications.

• Check for proper adhesion and remove any excess cement from the margins.

Aftercare: Instruct the patient to avoid excessive pressure on the treated area until the cement has fully set.

• Schedule follow-up appointments as necessary to monitor the integrity of the restoration.