• Material Type: Polyvinyl addition silicone
• Consistency: Putty
• Indications: Crown and bridge prosthetics
• Compatibility: All die materials
• Impression Techniques: One-step and two-step
• Mixing Ratio: Equal quantity of base and catalyst
• Color Indicators: Yes
• Dosage Control: Bleeding of light cartridge before each use
• Setting Time: Short

Prime Dental Ad-Sil Acura Kit (Hard Set) :

• 1 x 400g Base
• 1 x 400g Catalyst
• 1 x 50ml Base Cartridge
• 1 x 50ml Catalyst Cartridge
• 2 x Spoon

• Ensure equal quantities of base and catalyst for both putty and wash materials.
• Bleed the light cartridge before each use to ensure proper dosage.
• Keep the cartridge tip immersed in the light body during extrusion.
• Knead the putty material until it turns blue; mix the wash material until uniform in color.
• Dispense the wash material around the margin of the preparation using a syringe.
• Use a rigid tray with at least 3 mm space around for impression.
• Apply tray adhesive and allow it to dry before usage.
• Wipe teeth to remove excess blood, saliva, and water; drying is optional.
• Adhere to the specified setting time as per the provided table.
• Withdraw the impression carefully, breaking the seal and pulling away.
• Rinse the impression material under running water if needed, and use disinfectants as necessary.
• Avoid storing the impression in direct sunlight.
• Pour the model within 20 minutes of taking the impression; epoxy can be poured after 60 minutes.
• Use Prime Dental's Debubblizer to avoid surface porosity.