• Material Type: A-silicone based
• Setting Version: Fast Set
• Color: Orange
• Dispensing System: Jar
• Mixing Time: 25sec
• Insertion In Mouth At: 45sec
• Final Set Time (From Start of Mix): 1min 45sec
• Setting Time at: 25°C Room Temperature

• 1 x 100mm Base
• 1 x 100ml Catalyst
• 2 x Scoop

Mixing Process:

• Ad Sil Acura Bite Registration Putty should be mixed with an equal quantity of base and catalyst.
• Knead the putty with fingers until it turns orange, indicating the completion of the mixing process.

Application:

• Place the mixed putty onto the occlusal surface of the row of teeth for bite registration.
• Instruct the patient to close in centric occlusion during the setting process.

Recording Buccal/Labial Surface:

• Excess material on the buccal/labial surface can be pressed with a finger to ensure accurate impressions.

Setting and Removal:

• Allow the putty to set in centric occlusion as per the recommended setting time.
• Remove the set putty from the mouth after the setting process is complete.

Rinsing and Disinfection:

• Rinse the impression material under running water.
• Use disinfectants if necessary to maintain optimal hygiene.

Model Pouring:

• The model can be poured within 20 minutes of taking the impression.
• For epoxy, pouring can be done after 60 minutes.

Storage and Pouring Considerations:

• Do not store impressions in direct sunlight.
• Pour the model within 14 days after taking the impression.

Surface Porosity Prevention:

• Use Prime Dental's Debubblizer to avoid surface porosity in the final model.

Note: Setting time and other details are provided in the table below.