• Composition: Contains 5% hydrofluoric acid for effective etching.
• Viscosity:Gel viscosity 
• Safety: Easy to rinse off, leaving a clean surface for bonding.
• Sterility: Packaged to maintain sterility and usability in clinical settings.
• Store at temperature between 10°C to 24°C.
• Close the cap carefully after use.
• Keep away from moisture.
• Shelf life not affected after opening if stored in a cool dry place.

Prevest Denpro CeraEtch Etching Gel - 1.2ml

• 1 x 1.2ml Syringe
• 5 x Applicator Tips
• 1 x Instruction Manual

Prevest Denpro CeraEtch Etching Gel - 10ml

• 1 x 10ml Bottle
  1 x Instruction Manual

• Protective eye wear must be worn by the practitioner and patient and protecting gloves must be worn by the practitioner.
• Isolate the area to be etched with a rubber dam. Apply gingival barrier around the area to be etched.
• Remove cap from the CeraEtch syringe and attach dispensing tip and check the etchant flow
  through the tip before applying intra orally. Apply etchant to the dry porcelain for 90 seconds.
• Suction the porcelain etchant and rinse with a copious amount of water and air dry. The etched
  surface should dull and frosty.
• Apply 1– 2 thin coats of Silane-X with a brush tip applicator to the etched surface and allows to dry for 30 seconds.
• Apply Renew Universal / Total Etch Bonding adhesive and follow the instructions for bonding and restorative with composites or cements.

Warning :-

Read the instructions thoroughly before use of this product. Hydrofluoric acid is a very powerful chemical and extreme care must be taken while handling this product.