• Type: Polymer-based, chemical curing composite
• Filler Content: 80% w/w filler
• Shade: Universal A2, suitable for most patients weight: 14g Base Paste in Jar and 14g Catalyst Paste in Jar.
• Shade: Universal A2
• Application: Permanent filling material for anterior and posterior teeth

Composition:

• Base Paste: Urethane Dimethacrylate, Ethoxylated Bisphenol A Dimethacrylate, Triethylene Glycol
• Dimethacrylate, Barium Glass Powder, Fillers, Curing Agent, Stabilizer
• Catalyst Paste: Urethane Dimethacrylate, Ethoxylated Bisphenol A Dimethacrylate, Triethylene Glycol
• Dimethacrylate, Barium Glass Powder, Fillers, Curing Agent, Stabilizer, Pigments"

• 1 x 14g Base Paste in Jar
• 1 x 14g Catalyst Paste in Jar
• 1 x Mixing Spatula
• 1 x Mixing Pad
• 1 x Instruction Manual

• Clean the teeth to be treated with a fluoride-free cleaning paste.
• Using a minimally invasive technique/adhesive filling technique is recommended to preserve healthy tooth substance.
• Cleaning and drying the cavity has to be carried out with special preparations (e.g., hydrogen peroxide solution). Observe instructions for use when applying the bonding materials.
• Apply pulp protection when working in close proximity to the pulp. Lining deep cavities with a glass ionomer cement is recommended due to its release of fluoride.
• Bevel enamel margins and etch for 20 - 30 sec (Actino). Then thoroughly rinse and dry. Do not etch dentine for
  more than 15 sec when using the “total-etch-technique”.
• Use a suitable dental adhesive according to the instructions for use. Mix equal quantities of Self Comp base and catalyst paste on the mixing pad with a spatula for approx. 15 - 30 sec until homogeneous.
• Do not use the same end for base and catalyst paste as, dispensing of base/catalyst from their respective jars with same end of mixing spatula might lead to premature setting.
• Dry the cavity before application. The working time of Self Comp is approx. 2 min and the setting time is 3-4 min.
• Do not move strips or matrix during this time. Remove any large areas of excess material with diamond bur. Using discs of graduated grains or a finishing diamond (lingual, palatinal area) is recommended for finishing. Diamond metal strips are suited for the approximal area.
• Then polish with a suitable polishing paste.
• A fluoride varnish should be applied to all treated teeth to support re-mineralization.
• The dispensed material shall not be placed back in container and the dose once applied and used shall not be reused.