• SOLARE Sculpt incorporates three unique filler technologies Single Dispersed Nanofillers (SDN), Full-coverage Silane Coating (FSC) and High-performance Pulverised CERASMART (HPC). The combination of these technologies allows you to sculpt beautiful high gloss aesthetic restorations with benchmark strength, wear resistance and durability.

• SOLARE Sculpt has 300nm strontium nano ceramic fillers which are homogenously dispersed and individually silane treated. This strengthens the adhesion between nano ceramic and resin matrix for high flexural strength and a beautiful high gloss finish.

• 1 x 1.9gm Solare Sculpt Refill

STEP 1:

• Clean the tooth with pumice & water.Shade selection should be made prior to isolation.

STEP 2:

• Prepare cavity using standard techniques.Dry by gently blowing with oil free air.rubber dam is recommended to isolate prepared tooth from contamination with saliva,blood or sulcus fluid.

STEP 3:

• For bonding solare sculpt to enamel and/or dentine and/or glass ionomer base,use a light-cured bonding system such as solare universal bond.

STEP 4:

• Remove syringe cap and dispense material onto a mixing pad.

STEP 5:

• Place the material into the cavity using a suitable placement instruments.

STEP 6:

• After dispensing,screw plunger anticlockwise by a half to full turn to release residual pressure inside the syringe.

STEP 7:

• Replace cap immediately after use.

STEP 8:

• Contour using standard technique.

STEP 9:

• Light cure solare sculpt using a light curing unit.

STEP 10:

• Finish & Polish using standard techniques.