Engineered with the latest reciprocating technology:

• GOLD treatment
• Reciprocating motion
• Variable taper
• Evolving cross-section
• Optimized tip

Waveone Gold Rotary Files Assorted

•  Pack of 4 (Small, Primary ,Medium & Large )

• Review radiographs to determine the width, length, and curvature of the root canal.
• Access preparation:
• Create straight-line access to the canal orifice(s) and ensure proper shaping of the internal axial walls.
• After removing any WaveOne Gold Glider file or WaveOne® Gold shaping file from a canal, irrigate abundantly and frequently.
• If a file does not easily progress, remove it, clean and inspect the cutting flutes, irrigate, recapitulate with a size 010 file, and re-irrigate.
• Use a gentle inward pecking motion with short amplitude strokes to advance the files along a smooth glide path.
• Prepare straight-line access to the canal orifice.
• Use a size 010 hand file with a lubricant to explore the canal.
• Determine working length using a preoperative radiograph and/or apex locator.
• Irrigate the canal.
• Passively advance the WaveOne® Gold Glider file with gentle inward pressure until the full working length is reached.
• Irrigate the expanded glide path, recapitulate, and irrigate again.
• Confirm the working length before proceeding to shaping with the WaveOne® Gold shaping system.
  Establish straight-line coronal and radicular access.
• Use a size 010 hand file to verify a glide path to length.
• Expand the glide path to at least 0.15 mm using a manual or mechanical glide path file.
• Always start the shaping procedure with the PRIMARY WaveOne® Gold file (025/07 red) in the presence of sodium hypochlorite.
• Let the PRIMARY file passively progress through the canal, remove and clean it after shaping 2-3 mm, then irrigate and recapitulate with a size 010 hand file.
• Continue using the PRIMARY file to pre-enlarge the coronal two-thirds of the canal with gentle inward pressure and a brushing motion on the outstroke.
• In more restrictive canals, use a size 010 hand file to negotiate to the terminus and work it until it is loose at length.
• Establish working length, confirm patency, and verify the glide path.
• Expand the glide path to at least 0.15 mm using a manual or mechanical glide path file.
• Use the PRIMARY file to the full working length in one or more passes, remove it to avoid over-enlarging the foramen, and inspect the apical flutes.
• If the PRIMARY file does not progress, use the SMALL file (020/07 yellow) in one or more passes to working length, and then use the PRIMARY file to optimize the shape.
• Once the shape is confirmed, proceed with 3-D disinfection protocols.