Storage & Handling:

• Product can be stored at room temperature close the cap after each use to avoid the material curing from ambient light.

Shade Available.

• A1, A2, A3, B1, and Bleach.

• 1 x 500g Bottle

Preparation:

• Agitate or shake the resin bottle vigorously for at least one minute before pouring.
• When using a material tray, stir the material with a soft spatula, taking care not to damage the tray's film.
• The ideal working temperature for the resin is between 15°C and 30°C.

Design of the C&B Files:

• After obtaining intraoral scans from the patient, the crown or bridge is designed and provided in STL file format by a dental designservice or lab.
• Ensure that the working temperature remains between 15°C and 30°C.

Printing Process:

• Wear protective gear including nitrile gloves, protective clothing, goggles, and/or face protection during processing.
• Shake the material thoroughly for at least 3 minutes before pouring into the clean tray of the 3D printer.
• Avoid exposing the printing resin to daylight during decanting.
• Apply the recommended D Tech Accuprint C&B settings specific to your 3D printer.
• Check for air bubbles between the build platform and the tray before each print to ensure a successful outcome.
• Use caution to avoid damaging the FEP film when handling the resin.

Washing of 3D C&B:

• After printing, detach the print objects from the build platform using the supplied spatula.
• Clean the print object in two steps with isopropyl alcohol (IPA) using a cleaning bath:
  • 1st Wash: Clean for 1 minute and 30 seconds in an IPA solution.
  • 2nd Wash: Thoroughly clean for 1 minute and 30 seconds using fresh IPA.

Finishing and Post-Curing:

• Remove support structures, if present, with a fine diamond bur.
• Ensure that the printed object is not deformed.
• Post-cure the cleaned print objects to achieve the required material properties and biocompatibility, following the recommended curing profiles.
  • Example curing profiles: Asiga Flash Cure (low power) for 30 minutes or Ackuretta
  • Curie (High power flashing system) for 10 minutes.
• Remove any support marks and polish with cotton and leather polishing wheels for 1 minute each.
• For a better look and polish, consider using D Tech Pro-Glaze liquid and follow the provided instructions.