COMPOSITION:

BOND I:

Ethanol, Silane coupling agent and others

BOND II:

Acetone, 4-AET, UDMA, Polymerization initiator and others

• 1 x 6ml CRB 1
• 1 x 5mlCRB 2
• 25  x Microbrushes each (Pink & Yellow)
• Instructions
• 5 x Dispo Dish

• Treatment of the restoration surface (pretreatment) For intraoral repair Roughen the restoration surface with abrasives (Diamond point etc.). Rinse with water and dry. Then, treat the surface with phosphoric acid based etching agent if necessary. Rinse with water and dry. For extraoral repair Roughen the restoration surface with abrasives (Diamond point etc.) or sandblast with 50 – 100 μm alumina particles. Rinse with water. Then, treat the surface with phosphoric acid based etching agent if necessary. Rinse with water and dry
• For repairing metal-ceramic restoration including metal surface 2-1 Application of M.L. Primer (sold separately) Apply one coat of M.L. Primer using brush and leave undisturbed for 10 sec. 2-2 Application of opaquer (sold separately) Apply one layer of opaquer on the con- ditioned metal surface and light-cure using a dental handheld or laboratory light-curing unit
• Application and drying of BOND I Apply one coat of BOND I on the entire surface to be repaired using a brush. Leave it undisturbed for 10 sec
• Application and drying of BOND II Apply one coat of BOND II on the entire surface to be repaired using a brush. Leave it undisturbed for 10 sec
• Light-curing (irradiation) Light-cure the surface with dental handheld or laboratory light-curing unit.
• Application of composite resin Follow the instructions for use of resin material to be used.