COMPOSITION :

• Acetone
• Phosphonic acid monomer
• Thioctic acid monomer

STORAGE :

• Store at room temperature (1-30 °C/34-86 °F). Keep away from direct sunlight and any source of ignition.

• 1 x 5ml Bottle

DIRECTIONS FOR USE

• Pretreatment of the restoration surface
• Extraoral use
• Sandblast the adhesive surface of zirconia-based or alumina-based restoration with 50-100 μm aluminum oxide at approx. 0.2-0.3 MPa/2-3 bar. Then, perform ultrasonic cleaning and dry with clean air. Sandblast can be replaced by roughing the surface with a suitable abrasive (eg. diamond bur etc).
• Intraoral use
• Place rubber dam and avoid direct contact with oral tissue. Roughen the adhesive surface by using a dental abrasive (eg. diamond bur etc), rinse with water, and dry with clean air.
• Application of AZ Primer
• Dispense an adequate amount of AZ Primer on a dish. Apply to the entire adhesive surface in one layer with a disposable brush. Leave it undisturbed for 10 sec. and dry naturally.
• Bonding to the resin material
• Bond resin material according to the instructions for the use of each product.

Notes :

• Do not mix with any other primers or bonding systems.
• Tightly close the cap after each use as this product contains volatile components. Use all the dispensed material promptly.
• Use a saliva ejector or suction during the procedure.
• Avoid contamination of the restoration surface to be bonded. If the surface is contaminated by saliva or blood, thoroughly clean the surface with an alcohol moistened cotton ball. Then, dry and reapply the material.
• Use all the dispensed material promptly on one patient.
• Do not reuse disposable brushes to avoid cross-contamination.