Composition

LIQUID

• Copolymer of acrylicacid and tricarboxylic acid (Water solution) Deionised water
• Others

POWDER

• Zinc Oxide (ZnO) ＞70%
• Magnesia(MgO)
• Silicon Oxide(SiO2)
• Others

STORAGE

Store at room temperature (1-30 °C/34-86 °F). Avoid high temperature and high humidity. Keep away from direct sunlight.

PRECAUTIONS

1. Do not use this product on patients with known allergies to this product or polycarboxylate cement. 2. Operators with known allergies to this product or polycarboxylate cement must not use this product. 3. If any inflammation or other allergic reactions occur on either patient or operator, immediately discontinue use and seek medical advice. 4. The liquid and mixture of this product should not come in contact with intraoral soft tissue, skin or eyes. In case of accidental contact with intraoral soft tissue or skin, immediately blot with alcohol moistened cotton ball and rinse with plenty of water. In case of contact with eyes, immediately flush the eyes with plenty of water and seek medical advice. 5. This product contains free silica. Inhalation of free silica for long periods could cause damage to the lung. Use local dust extractor, dust protective mask, etc to avoid harmful influence of the dust on the human body. 6. This product is intended for use by dental professionals only.

Shofu Hy - Bond Temporary Cement Soft Mini Set:

• 1 x  60gm Powder
• 1 x 35gm / 30ml Liquid

Shofu Hy - Bond Temporary Cement Soft Set:

• 1 x 125 gm Powder
• 1 x 70gm Liquid

• Standard Powder/Liquid Ratio - 2.2 g / 1.0 g . Dispense one level scoop of powder onto a mixing pad using the measuring scoop provided. Then, dispense two drops of liquid separately
• Mixing - Divide dispensed powder into 2 equal portions; introduce the first half to the dispensed liquid and mix with a spatula within about 15 - 20 seconds. Then, incorporate the remaining half gradually and mix the whole until it becomes a homogeneous paste. Mixing must be completed within about 45 seconds
• Temporary cementation/sealing - Immediately use the mixture for cementation, sealing or lining
• Setting and removal of excess material - After cementation or filling, keep the area from being contaminated with saliva for about 8 minutes. Then, remove excess hardened material following the conventional method
• Removal - Remove provisional restoration and residues of this material. Thoroughly clean the tooth surface for permanent restoration.