TECHNICAL SPECIFICATIONS:

• Power Supply: 220V/110V 50/60Hz
• Power: 150W
• Bowl Capacity: 500ml
• Mixing Speed: 270rpm
• Built-in Vibrator: Variable Speed
• The Degree of Vacuum Less: 0.085Mpa
• Shock mode: stepless
• Gross Weight: 27kg
• Dimensions: 43x43x58cm

• 1 x Host (including vacuum pump)
• 1 x Power Cord
• 1 x Mixing Bottle
• 1 x Stirring Shovel
• 2 x Fuse
• 1 x Manual

• Setup: Ensure the machine is on a stable and level surface. Connect it to a power source following the manufacturer's guidelines.
• Prepare Materials: Place the investment or molded materials in the mixing container, adhering to recommended proportions and specifications.
• Close the Lid Securely: Ensure the mixing container is properly positioned, and securely close the lid to create a sealed environment.
• Connect the Vacuum Pump: Connect the machine to the vacuum pump using the provided connections. Check for any leaks or loose fittings.
• Start the Vacuum Pump: Power on the vacuum pump. Allow it to reach the desired vacuum level, typically specified by the material being used. Refer to material guidelines.
• Initiate Mixing: Activate the mixing function on the machine. The vacuum state will assist in removing air bubbles from the material, ensuring a homogeneous mix.
• Adjust Vibration Amplitude (if applicable): If the machine has adjustable vibration amplitude, set it according to the desired specifications for your application.
• Monitor Mixing Process: Observe the mixing process through any transparent sections on the machine or by periodically stopping to check the material consistency.
• Stop Mixing: Once the mixing process is complete, turn off the mixing function and then power off the vacuum pump.
• Open the Lid: Carefully open the lid of the machine, and retrieve the mixed material.
• Clean the Machine: Thoroughly clean the mixing container and any components that came in contact with the materials. Follow the manufacturer's cleaning instructions.
• Power Off: Turn off the machine and disconnect it from the power source.