• Template Material: Translucent Medical-grade Plastic 
• Coating: Nonstick
• Sterilization: Autoclavable (Maximum temperature: 137°C / 278°F)
• Anatomical Design: Mimics Ideal Tooth Anatomy (Height-to-Width Ratio, Contour, Embrasure, Center Midline)
• Applications: Direct Composite Veneer, Cosmetic Mock-ups, Shade Selection, Temporaries, Class 3, 4, and 5
• Curing Process: Allows Light Transfer from Curing Light through to Composite 

• 1 x Uveneer Template Refill (32 templates)

Step 1

• Choose Mosaic universal composite or preferred composite shade(s). Select the template that corresponds with the tooth being restored. See the handle of the template for the corresponding tooth number, size, and arch.

Step 2

• Remove all caries if needed and minimally prepare the tooth.​

Step 3

• Place interproximal separating matrices and apply Ultra-Etch etchant, Peak SE Primer, or preferred etch.

Step 4

• Rinse etchant gel

Step 5

• Apply Peak Universal Bond adhesive or preferred adhesive to tooth surface.

Step 6

• Light cure with LED curing light

Step 7

• 
  Apply Mosaic universal composite or preferred composite directly onto the tooth.

Step 8

• ​Do not light cure composite.

Step 9

• ​Select chosen Uveneer template. Template should ideally cover the entire facial surface of the tooth. If not, additional composite may be used at the periphery to compensate.

Step 10

• Align centerline of template parallel to the midline of the face and perpendicular to the incisal plane. Using thumb, press the concave side of the selected template onto the tooth. Press firmly to remove any trapped air

Step 11

• Remove any excess composite from the periphery.

Step 12

• ​Using VALO curing light, cure composite through template. For every 2mm layer, cure 1–2 x 10 seconds on Standard Power, 1–2 x 4 seconds on High Power, or 1–2 x 3 seconds on Xtra Power.

Step 13

• ​Remove the Uveneer template by gently lifting the handle. Using VALO curing light do final cure directly onto composite. To ensure composite is cured thoroughly, for every 2mm layer, cure 3 x 10 seconds on Standard Power, 3 x 4 seconds on High Power, or 3 x 3 seconds on Xtra Power.

Step 14

• Avoiding the glossy facial surface, trim excess composite from periphery with a fine flameshaped bur in Jiffy™ Composite Finishing Bur Kit. Use Jiffy™ Composite Polishers, Brushes, Diamond Strips, or Proximal Saws for minimal finishing and adjusting if desired.

Step 15

• ​Immediately after use, thoroughly wipe template with alcohol pad, dry, bag, and autoclave according to Uveneer template IFU. Do not leave any composite residue on the template in order to maintain translucency and shine.