• Material Type: Light-cured, radiopaque liner and base material
• Composition: Calcium hydroxide, calcium hydroxyapatite, urethane dimethacrylate base
• Calcium Release: Superior calcium release
• Delivery Method: Controlled syringe delivery
• Adhesion: Self-adhering

• 1 x syringe of 1.2 ml

Ultra-Blend™ plus Liner Application:

See Instructions for Use for complete instructions, warnings, and precautions.

Step 1

Small Exposure

Use Ultra-Blend plus liner near pulp (pink) and for small nonhyperemic exposure. For larger exposure and/or hyperemic pulp, endodontic therapy should be considered.

Step 2

Consepsis™ Solution

Apply Consepsis™ antibacterial solution with plastic Blue Mini™ Dento-Infusor™ or Black Mini™ Brush tip for 60 seconds. Let sit. Do not scrub. Air dry.

Step 3

MTAFlow™ Cement

Optional: If the exposure is larger than a pinhole, apply MTAFlow™ cement onto and slightly around the pulp exposure. Remove excess material with a dry cotton pellet. When pulpal floor is clean and dry, place Ultra-Blend plus liner, overlapping slightly onto sound dentin to maximize surface area for dentin bonding. If the pulp is hyperemic, endodontic therapy should be considered.

Step 4

Ultra-Blend plus Liner

With Black Micro™ tip, apply Ultra-Blend plus liner to dry dentin for direct or indirect pulp caps and light cure. Minimize dentin coverage to maximize available dentin for bonding.

Step 5

Ultra-Etch™ Etchant

Apply Ultra-Etch™ 35% phosphoric acid etchant solution for 15 seconds. Suction, rinse, and dry until damp. NOTE: If desired, apply Consepsis solution prior to bonding, then place again for 60 seconds. Dry until dentin is slightly moist and proceed to the bonding agent.

Step 6

Dentin Bonding/Peak™ Universal Bond Adhesive

With the Inspiral™ Brush tip, apply Peak™ Universal Bond adhesive, paint onto enamel and scrub into dentin for 10 seconds. Air thin at half pressure for 10 seconds and light cure for 10 seconds with the VALO™ curing light on Standard Power mode. Restore with a quality composite.