COMPOSITION:

35% by weight methacrylate ester. 65% by weight inorganic filler.

TECHNICAL DATA:

• Working time at room temperature: 2 minutes
• Net setting time at oral temperature: 5 minutes
• Light-curing time: 20 seconds

SDI SeT PP Syringe Shade A2/Translucent:

• 1 x 7g Syringe

SDI SeT PP 50 Capsules Shade A2:

• 50 Capsules of A2 Shade

INSTRUCTIONS FOR USE:

TOOTH PREPARATION:

1. Select the appropriate shade of ‘seT PP’

2. Remove the temporary restoration and clean the preparation thoroughly using an oil free pumice to remove any remaining temporary cement

(NOTE: temporary restoration should only be seated with eugenol-free cement)

3. Try in the restoration

4. Again, clean with water and dry, but DO NOT DESICCATE.

WARNING: In cases where pulp protection is necessary, use a hard setting calcium hydroxide liner before the final impression is made. Substances such as hydrogen peroxide, desensitizers, disinfectants, astringents and dentin sealants etc should not be used as residues may interfere with bond strength and setting reactions.

RESTORATION PREPARATION:

Clean thoroughly and prepare the restoration according to manufacturer’s instructions.

PREPARATION OF SYRINGE:

Remove cap. Dispense 2-3mm of material onto a pad and discard (to ensure correct ratio of extrusion). Attach a mixing tip to the syringe

MIXING BY HAND:

Without mixing tip attached, extrude even amount of material onto mixing pad. With a suitable spatula mix the two pastes together for 30 seconds

APPLICATION of ‘seT PP’

1. Protect the work area against contamination from intra-oral fluids

2. Place or extrude ‘seT PP’ evenly onto all bonding surfaces of the restoration and tooth.

NOTE: Do not use Lentulo-Spirals to insert the cement into root canals, as this can excessively accelerate setting. Also to avoid entrapping air, vibrate posts while inserting into root canal.

NOTE: In the case of veneers, use an adhesive (Go!, Stae, etc according to manufacturer’s instructions including any etching procedure) prior to seT PP to improve the retentive strength. Cement only 1-2 veneers at a time due to limitation of the paste’s working time.

3. Seat restoration, and leave for 30 seconds before any light curing is carried out

4. Trim excess material away after light curing for 2 seconds or after 2 minutes from start of mixing

NOTE: If excess cement is removed with a sponge pellet or a similar implement leave a minimal amount of excess after restoration is seated. Immediately after, either briefly light-cure the excess or if allowing to self-cure cover the excess with glycerine gel to prevent oxygen inhibition

5. Light cure thoroughly to speed up setting process (minimum 20 seconds per surface). In the case of composite and all ceramic materials, light cure ‘seT PP’ through the restoration

6. Polish marginal area